- 1). Look directly below the front bumper, on both the passenger's and driver's side. Locate the fog light assembly on both sides, they are small, round lights.
- 2). Look at the trim surrounding the fog light and locate the two screws holding it. Loosen and remove these screws using a Phillips screwdriver.
- 3). Pull the trim from the fog light.
- 4). Grasp the fog light assembly and pull it from the vehicle.
- 5). Look on the rear of the assembly and locate the two wires plugging into the assembly. Grasp each wire and pull it from the assembly.
- 6). Look at the rear of the fog lamp assembly and locate the metal clip holding the light bulb in place.
- 7). Push downward on the clip and unhook it from the fog light assembly. Swing the clips over and away from the bulb.
- 8). Grasp the fog light bulb and pull it from the fog light assembly.
- 9). Push the new fog light bulb into the assembly. There are grooves to guide the bulb in correctly.
- 10
Hold the bulb in place, swing the metal clip back over the bulb and hook it into place on the assembly. - 11
Plug the two wires back into the fog light assembly. The clips are different sizes to prevent incorrect wiring. - 12
Push the fog light assembly back into the hole below the bumper. - 13
Place the trim piece back over the fog light assembly. - 14
Tighten the screws using a screwdriver. - 15
Repeat Steps 2 through 14 for the fog light on the other side.
previous post
next post