Metal Tent Poles

• 1). Use grommets when your frame consists of metal tent poles you plan to use freestanding in your yard.
  
  
• 2). Fold your shade cloth in half to find the middle. Use a marker to make an "X." Place an "X" on the middle of the two folded sides. Fold the fabric in half the opposite way to find the halfway points on those sides as well and mark with the marker.
  
  
• 3). Place an "X" at each of the four corners as well.
  
  
• 4). Use the tools that came with your grommets to install the grommets at each "X."
  
  
• 5). Insert the tent poles into the grommet holes and tie down the shade cloth with ropes and metal stakes.
  
  

PVC Pipes

• 1). Sew your shade cloth to the necessary measurement for your PVC pipe frame, but make casings at the sides where you can insert the PVC pipes.
  
  
• 2). Make a casing by folding the shade cloth over 3 inches and again another 3 inches. Hold the fabric in place using clothespins or masking tape. Sew along the edge of the casing.
  
  
• 3). Insert the PVC pipe frame into the casing.
  
  

Wood Frames

• 1). Use screws and metal washers to attach your shade cloth to a wooden frame.
  
  
• 2). Measure and mark out where you want to put the screws. Plan a screw every 10 inches.
  
  
• 3). Place the screw through the washer and drill the screw directly into the wood frame.
  
  

Shade Cloth Clips

• 1). Buy special clips for attaching your shade cloth; these work with any type and size of frame.
  
  
• 2). Purchase the clips from the same company where you purchase your shade cloth. Plan to use one every 10 to 12 inches.
  
  
• 3). Clip the shade cloth onto the frame. Use the clips for shade cloth that you want to remove from time to time, instead of using the more permanent screws.