- 1). Use a small paintbrush to apply a thin layer of craft glue to the back of the pressed edelweiss flower. Position the flower in the pendant frame where you want it to be. Hold the flower in place for 30 seconds or until the glue adheres.
- 2). Use a clean paintbrush to apply a layer of decoupage glue over the flower and the surrounding backing inside the frame. Apply two more layers of the glue. Allow the glue to dry for an hour before continuing.
- 3). Dip an orangewood stick into the doming resin. Drip the resin into the center of the pendant frame. Allow the resin to spread out on its own, gently guiding it with the orangewood stick. Add additional drops around the periphery of the initial dot, if necessary. Check that the resin fills the frame completely and is flush against all sides. Let the resin dry for 24 hours.
- 4). Open a jump ring with pliers. Slip the jump ring through the loop at the top of the pendant. Clamp the jump ring close. Slide the pendant onto the necklace chain. Wear as desired.
previous post