- 1). Turn on your Phillips TV.
- 2). Press "SEL/OK," then "Mute" simultaneously until the mode buttons illuminate. (They will alternate in slow rotation between modes.)
- 3). Enter the TV code on the keypad of the remote. The TV will turn off if the correct code is entered. (You may have to try several different codes before selecting the correct code.)
- 4). Press "Mute" after the correct code has been entered.
- 5). Press the "SEL/OK" button if the TV turns back on. This will lock in the code. The mode buttons will blink three times, then go off.
In the event that the TV does not turn back on after pressing "SEL/OK," continue entering 3-digit setup codes until the TV turns back on. Press "SEL/OK" to lock in the code. - 1). Turn on the Phillips TV.
- 2). Press the "TV" device key once. (It will blink one time.) Press and hold "Setup" until the "TV" mode key blinks two times.
- 3). Enter the first code for your TV. If you have entered the correct code, the "TV" mode key will blink two times. If the "TV" mode key emits a long blink, an invalid code has been entered. Repeat the code entering process with the same code.
- 4). Aim the remote control at the TV and press the "Power" button one time. The device should turn off. If it does not, an invalid code has been entered. Repeat the code entering process with a different code.
- 1). Turn on the Phillips TV.
- 2). Press the "TV" device button and the "SELECT" button simultaneously for three seconds. The "TV" LED will turn on for 20 seconds.
- 3). Point the remote control toward the Phillips TV and enter the three-digit code number within the 20 seconds that the "TV" LED is on. The TV will turn off when the correct code has been entered. If it does not, an invalid code has been entered. Repeat the code entering process with a different code.
- 4). Store the code by selecting the "TV" device button on the remote. The LED associated with the "TV" device button will illuminate two times to indicate that the code has been stored.
next post