- 1). Empty any old gas out of the gas tank. Refill the tank with an 87 octane or higher gasoline after completing your tune up. Don't put in more gas than you will use in 30 days.
- 2). Tip your snow blower on its side and inspect the scraper bar for wear. This part scrapes against the ground to remove the snow, and will need to be replaced periodically.
- 3). Check the rubber around the auger. If you can place your finger between the rubber and the auger, it is time to replace it for better performance.
- 4). Tighten all the screws and bolts on your snow blower. A loose bolt on the handle can cause it to snap off when you apply pressure.
- 5). Take the belt cover off and check the belts for cracking and wear. While you have the cover off, check the pulleys to be sure they are not loose. Tighten if necessary.
- 6). Change the oil with a 5W30 motor oil. The Craftsman 5/23 has a four-stroke engine, so the oil is not mixed in with the gas, necessitating an oil change once a year. You should check your oil level before each time you start your engine.
- 7). Replace the spark plug. This will ensure easier starting.
- 8). Start the snow blower and let it run for a few minutes after refilling it with gas. This will burn any old gas out of the fuel lines or the carburetor.
previous post