- 1). Unplug the dryer. Loosen the screw heads that are on the inside of the opening where the door is, front facing up. Remove the top panel.
- 2). Reach down inside the open dryer, loosen the screws that hold the front panel in place and remove the front panel. The dryer's drum should be completely exposed.
- 3). Locate the rubber belt encircling the drum. Trace it to where it threads through the motor. Mark with your chalk on the drum at the point where the belt lifts off the drum to go into the motor.
- 4). Slowly turn the drum. As it turns, spray belt dressing onto the back of the belt at the point where it lifts off the drum.
- 5). Continue turning the drum and spraying the back side of the belt until the chalk mark that you made comes back around.
- 6). Reassemble the housing of the dryer, replacing all of the screws where they were originally. Plug the dryer in and test for the noise.