Discussion
The current study demonstrates that anatomical or nearly anatomical reduction and satisfactory fixation of an olecranon fracture was obtained in all 26 patients treated with a central tension plate with a sharp hook. No fixation failures were reported. At the latest follow-up, no patient required plate removal secondary to symptomatic hardware complications. The range of motion of the injured elbow was greatly improved from the earlier postoperative time, and according to MEP and DASH scores, satisfactory functional recovery was achieved in all patients. The indications for central tension plate fixation include displaced unstable oblique and comminuted olecranon fractures. This technique is also suitable for transverse olecranon fractures in high-demand patients.
Early range of motion has been considered a critical aspect in postoperative care of olecranon fractures. Restoration of articular congruity and rigid internal fixation are therefore essential in the treatment of intra-articular fractures, as they permit early postoperative range of motion. The challenge for these fractures, however, is that because of the subcutaneous nature of the proximal ulna, hardware prominence is common. Hardware prominence often causes discomfort to the patient, and is a reason to necessitate its removal. Indeed, prominent hardware requiring removal remains one of the most common complications following internal fixation of olecranon fractures, and up to 20% of plates have required removal to manage patient reported symptoms of discomfort. Similarly, 80% of TBW fixations reportedly are removed because of migration and painful irritation. Knowing that hardware prominence is such a common surgical complication, the central tension plate was designed to have a low profile, and the proximal component is in the shape of a gourd in order to better match the olecranon osteology. The sharp hook is inserted into the triceps tendon and positioned closely to the dorsal surface of proximal ulna. In the present case series, no symptomatic hardware removal was required. Mild pain over the elbow was noted in one patient, however, it was felt to be a result of the prominent end of a single screw.
To position a standard plate properly on the posterior surface of the ulna, it has been recommended that the triceps fascia and tendon be partially split, allowing the implant to rest directly on the bone. There is the risk, however, that by splitting the tendon and fascia the triceps muscle strength of the operative extremity will be impaired, even if the tendon is sutured and reattached to the ulna once the plate is in place. Using the central tension plate, the sharp hook can be directly inserted into the olecranon through the tendon of triceps muscle without making an incision. This may result in less injury to the triceps muscle than as seen secondary to routine posterior plating. It has been found that patients with isolated olecranon fractures typically lose 10° to 15° of extension, and this deficit is even greater when there is an associated fracture of the radial head or coronoid. The data from the present study demonstrated that at follow up the range of motion of the affected elbow could return to near preoperative values, as the flexion and rotation of the affected elbows were similar to the unaffected ones, and the extension of the affected elbow was on average only 2 degrees less than the contralateral uninjured elbow.
Posterior plating is commonly used to manage olecranon fractures, as it facilitates fracture reduction and is stronger than medial or lateral plating. Gordon et al. reported that a posterior plate on the dorsal surface of proximal ulna with an intramedullary screw was significantly stronger than even dual medial and lateral plating. In our study, all plates were placed on the dorsal surface of the ulna, which can improve the rigidity of fixation. The shape of plate also influences the rigidity of fixation. Reconstruction and one-third tubular plates may not resist saggital plane bending forces in those fractures with intercalary comminution, bone loss, concomitant radial oblique fractures or radial head subluxation. In these situations, a stiffer implant should be considered. The body of the newly designed plate is v-shaped. It is known that a v-shaped construct is stronger than tubular constructs, and can better resist the saggital plane bending forces. At follow up, no loss of reduction was observed. Rigid internal fixation permits early exercises, and good or excellent functional recovery of the elbow was achieved in all patients in this case series.
There are limitations to this study, in particular its retrospective nature and the small number of patients treated with the central tension plate with sharp hook. As this study only reports the results of those patients treated with the central tension plate, a randomized controlled study with a control group of those patients treated with other commonly used plates or TBW should be performed in order to determine the definitive role of this new plate in treating the intra-articular olecranon fractures.