- 1). Tighten the bad saw until the blade will only move a quarter of an inch.
- 2). Move the thrust bearing so that it's a hair's length away from the saw blade.
- 3). Adjust the saw blade guides until the teeth of the blade barely poke out.
- 4). Turn the tracking until the blade is in the center of the band saw wheels.
- 5). Close the wheel covers.
- 6). Lower the blade guide to its working height.
- 7). Start the saw to make sure its properly set in its tracking.
- 8). Tighten the blade until it stops vibrating.
previous post